Guest
Show Posts
11
General Mach Discussion / ShuttlePro VID Number?
« on: April 01, 2009, 02:13:36 PM »
I'm trying to get my Contour ShuttlePro working with Mach 3....
I followed the documentation, installed the ShuttlePro software and tested the unit (everything seemed fine), uninstalled the ShuttlePro software, and can find the ShuttlePro plug-in under the "Config Plug-ins" menu.
My problem comes with Step #8 in the documentation. it says that the "Vendor ID for the Contour Shuttle Products should always be 0B33".
My ShuttlePro (Model # SP-JNS) comes up with "USB\VID_05F3&PID-0240\5&201D6F28&0&2 "..... which I take to mean a Vendor ID of 05F3.
I can't find any of the 5 Config menu choices that give me anything other than a "No Shuttle of Type Detected" in the status window of Mach3.
Does anyone have any suggestions? ... or am I the semi-proud owner of a bastard step-child ShuttlePro that is not supported?
Thanks!
-Taylor Collins
I followed the documentation, installed the ShuttlePro software and tested the unit (everything seemed fine), uninstalled the ShuttlePro software, and can find the ShuttlePro plug-in under the "Config Plug-ins" menu.
My problem comes with Step #8 in the documentation. it says that the "Vendor ID for the Contour Shuttle Products should always be 0B33".
My ShuttlePro (Model # SP-JNS) comes up with "USB\VID_05F3&PID-0240\5&201D6F28&0&2 "..... which I take to mean a Vendor ID of 05F3.
I can't find any of the 5 Config menu choices that give me anything other than a "No Shuttle of Type Detected" in the status window of Mach3.
Does anyone have any suggestions? ... or am I the semi-proud owner of a bastard step-child ShuttlePro that is not supported?
Thanks!
-Taylor Collins