Messages

21

General Mach Discussion / Re: Won't load G Code?

« on: April 13, 2009, 09:38:39 AM »

Hood,

It's not a demo. I have attached the XML.

22

General Mach Discussion / Won't load G Code?

« on: April 12, 2009, 10:33:16 PM »

  Mach 3 won't load the full G Code sample Cross.tap

Everything was fine I could load the full Cross.tap and then I started setting the homing, table size, etc.. and when I re-gen toolpath not all the G code loads up only a small part of it.

It wont load any G Code generated in V Carve for Mach2/3 Inches, I always get a circle starting at the 0 point.

I want to start cutting but I don't know the problem 

23

Show"N"Tell ( Your Machines) / Re: Router plans

« on: April 11, 2009, 01:27:28 PM »

Mechmate rocks!!! I hope to build one soon.