Hello Guest it is March 28, 2024, 06:32:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - RHOLLIDAY

Pages: 1
1
General Mach Discussion / Port 2 not switching to inputs
« on: June 06, 2011, 04:50:10 PM »
My port 2 will not read inputs on pins 2 to 9.
The brake out board  checks out OK the pins at the db24 connector go low and high but mock3 diagnostics all leds are on.
Port 2 is checked for inputs. 


Robert

2
General Mach Discussion / MPG on print port 2
« on: April 25, 2009, 02:36:34 AM »
I assigned the MPG to the MPG DRO 1 , the axis selector switch and scaling switches to OEMTRIG 1 through 6.  In jog mode MPG when I click on MPG axis ALT A each axis will move when selected.
How do you assign the axis  selector switch to set the proper axis and how to set the 1x ,10x and 100x scaling factors?

3
General Mach Discussion / HOME SWICH NOT REVERSING and LIMIT SWITCH
« on: April 08, 2009, 04:58:17 AM »
Retrofitting a Sharp mill. I have the x-- limit and x home on one switch with a separate switch for x+. The limit override led is on.
 When I reference x home, X goes to home and stops but will not back off the switch and the limit switch is triggered. To get off the
switch I have to turn off the X-- input. Then when I home it will home and zero the DRO but not move off the switch.
Same problem on the Y and Z
  

 Robert

Pages: 1