Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jve

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »

General Mach Discussion / Re: Soft stop at limit switches

« on: September 14, 2010, 02:32:42 PM »

hi guys
i was just reading this topic and i always try to use the softlimits but i am retrofitting a big cnc lathe with mach3 turn and some how i canot config the soft limits settings
i am working with the machine and i am trying to understand the soft limits settings
do you guys use softlimits in mach3 turn?

Brains Development / Re: Spindle% in MachTurn

« on: August 09, 2010, 01:45:04 PM »

i have same problem i cannot move dro74 in mach3 turn but it works in the mill

General Mach Discussion / Re: mach3 tool remember

« on: July 17, 2010, 12:20:06 PM »

i am using allen bradley micro logics via modbus
if i can help you let me know

General Mach Discussion / Re: mach3 tool remember

« on: July 16, 2010, 12:30:38 PM »

it was exectly as you said hood there was a macro pump that was reseting the tool to 1
many thanks hood

General Mach Discussion / Re: mach3 tool remember

« on: July 14, 2010, 12:45:01 PM »

i dont think that it is a ladder problem but i will try to check , the problem is as soon i press the reset the user dro 2000 is sending 1 to the plc but now i am trying this at home and as you said it is working properly and now i am realy confused

shall i uninstall mach3 and try to set up again ?

General Mach Discussion / Re: mach3 tool remember

« on: July 13, 2010, 03:13:36 PM »

the brain is sending the tool number to the plc via modbus after the tool change is ready controled by the plc then the plc send a bit which mach3 recive and conected to input 4 so when mach3 recive input 4 means that toolchange is ready the problem is when i hit the reset the brain send for tool 1

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »