Messages

21

General Mach Discussion / spindle problem

« on: March 25, 2015, 01:55:16 PM »

hi all,

i been using mach 3 for several times and today i tried to make a spindle working 0 to 10v with a csmio controller i manage to make it working with no problems it is varying but this is the most strange thing that i have when you type in the mdi m3 s1000 the spindle starts and it will run 1000 but if i type 2000 the spindle will keep 1000 then when i press reset spindle over ride it will go 2000 so basically i have to press the reset spindle override to ghange the spindle speed after i type in mdi or in g code  file 
do i am missing something ??

22

General Mach Discussion / atc macro

« on: August 12, 2014, 06:30:05 AM »

hi all,

i am sure that some of been pass this before i need a macro for a atc which has 10tools along the y axis not with pocket it has to slide in with the x axis anyone has something ready and i will modify 

23

General Mach Discussion / Re: csmio

« on: July 01, 2013, 03:12:07 AM »

now i think it is working ok cause i modify the program in the beginning it was on g94  and then i made G95 on top of the G76 and it is working ok now but i think i sill have a issue with the spindle true

24

General Mach Discussion / Re: csmio

« on: July 01, 2013, 02:45:48 AM »

i also notice that i had set the spindle 800 rpm and now spindle true is 794 when i un tick the closed loop spindle control

25

General Mach Discussion / Re: csmio

« on: July 01, 2013, 02:31:54 AM »

ok i did have a first improvement now the spindle is not slowing down on evrey pass but i still have the issue that when it makes the pass and the tool is inside then the machine it has to go out on the x axis to clear from the tread and it is going very slow if you have team viewer i can show you exactly what it is doing

26

General Mach Discussion / Re: motors wont run

« on: June 30, 2013, 11:31:16 PM »

you have to give more info what kind of breakout board are you using ?

27

General Mach Discussion / Re: csmio

« on: June 30, 2013, 12:05:57 PM »

what should i do then?
could it be a macro doing this?

28

General Mach Discussion / Re: csmio

« on: June 29, 2013, 05:07:13 PM »

yes spindle true and rpm are ok but my plugin is the latest v2,30

29

General Mach Discussion / Re: flying saw by mach3

« on: June 29, 2013, 10:16:25 AM »

where you from ?

30

General Mach Discussion / Re: flying saw by mach3

« on: June 29, 2013, 09:19:27 AM »

yes it can