Topics

21

General Mach Discussion / how i can write a message

« on: October 24, 2009, 11:59:06 AM »

 hi guys
to day i finish my toolchanger and now i need a message that come up when i have input 3 activate i need this because i have a lube pump and it give you a contact when it is empty so it will be nice to have mach3 to tell you to fill it up , i am sure that this was done before but i cannot find any example of a vb to do that
can some one help me to do that
regards
jekran

22

General Mach Discussion / encoder feedback

« on: September 26, 2009, 01:00:50 PM »

hi guy
i have a mill and i notice that when i press the reset button on mach3 i am loosing position is it possible to make encoder feedback via 2nd parallel port i have the encoder feed back on my servo drives A+ A- B+B- Z+Z- did any one did this before
regards
jekran

23

Modbus / com1 & com2 modbus

« on: September 26, 2009, 11:44:04 AM »

i have a mill working with mach3 and it has a toolchanger working with A/B plc via modbus on com1 i was wondering if it is possible to connect a peter homann modio on com2 
thanks in advance
jekran

24

General Mach Discussion / 16 atc via modbus

« on: August 09, 2009, 02:39:04 AM »

hi guys
i just made a setup in a ab plc (micro logics 1100) i conect it with mach3 and i have comunications my problem is that i need to write and reed from mach3 and i dont know wich way is the simpler brains or vb my plc is waiting for 4 bits 80,81,82,83 so when the plc recive the binary code of those bits it means the tool position did any one did this type before so i can see the vb or brains for the m6 and have idea how to make it
regards
jeffrey