Hello Guest it is January 23, 2022, 01:16:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - miics

Pages: 1
General Mach Discussion / DRO Issues Pls help
« on: March 27, 2009, 09:44:32 AM »
Hi all I'm new here si please be gentle.  I have today finally got everything i need to get the motors rolling.  i have installed mach3 (licenced) on my computer (ibm thinkpad pentuim m 1.7g 512mb ram).  when i go to my quickstart preload, all is good for about 3 - 4 seconds.  If i toggle xy or z they move fine but then after the 3 or 4 seconds, everything seemd to stop.  if i hold down say the page down key, the z that momentarily had moved fine, will now only click step at a time (if that even).  I know it sounds like i am rambling, i am very new in the world of cnc.  I have tried to change motor speeds etc, but that doesn't fix anything.  the problem is present even if i press the tab key and shuttle with the mouse.

please help if you can.

thanks in advance


Pages: 1