Hello Guest it is April 29, 2024, 07:59:21 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jordan21

Pages: « 1 2
11
General Mach Discussion / I need help setting up my air drill
« on: March 27, 2009, 02:11:25 PM »
I have installed an air drill on my router next to my spindle, using the same z plate.  I'm not too familiar with mach3.  How would one go about configuring mach3 to run it.  I need some direction.  Thanks in advanced

Pages: « 1 2