Hello Guest it is March 28, 2024, 01:00:30 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Jerry Bradley

Pages: 1
1
General Mach Discussion / Early Version of MAXNC Closed Loop System
« on: March 24, 2009, 03:41:07 PM »
This is my first post on this forum, so hope this is the appropriate location. I have an early (1999) version of the close loop system which I am trying to get operating under Mach III.  This version required two bidirectiional printer ports and ran under DOS. Can anyone provide assistance? I can get some movement on some of the axes using the MAXNC-10 Wave Drive, but not with the Max CL Mode enabled boxes checked. 

The users manual that came with the system is titled "MAXNC SRV-S. I am working with Chris at MAXNC, but he is not familiar with this version.

According to the manual, this is the structure:
 
Port Address 1 -- X&Y codes -- 278 Hex
Port Address 2 -- X encoder input -- 27A Hex
Port Address 3 -- Yencoder input -- 279 Hex
Port Address 4 -- Z&A codes -- 3BC Hex
Port Address 5 --  Z encoder input -- 3BE Hex
Port Address 6--  A encoder input -- 3BD Hex

Thanks,

Jerry

Pages: 1