21
General Mach Discussion / Re: Probe Installation Problems!!!!!!!!!
« on: May 26, 2010, 07:48:41 AM »
I think that we both have the same set up. I never used a probe nor have I ever built or run a CNC mill before. This is a hobby for me.
I bought a probe from wildhorse and did try to set it up as a NC switch. I have a CNC4PC Break Out Board wher I hooked up the yellow wire to pin 15 and the red wire to 5V.
In Mach3 Config>Ports and Pins>Input Signals I enabled the "Probe" used Port#1 Pin Number 15 and checked Active Low.
That being said I don't think my system is working correctly. I wish there was a tutorial on using the Probing plug-in and set up. Have you found out anything new or is your probe working?
Maybe between the two of us we can figure this out.
I bought a probe from wildhorse and did try to set it up as a NC switch. I have a CNC4PC Break Out Board wher I hooked up the yellow wire to pin 15 and the red wire to 5V.
In Mach3 Config>Ports and Pins>Input Signals I enabled the "Probe" used Port#1 Pin Number 15 and checked Active Low.
That being said I don't think my system is working correctly. I wish there was a tutorial on using the Probing plug-in and set up. Have you found out anything new or is your probe working?
Maybe between the two of us we can figure this out.