Hello Guest it is November 30, 2020, 03:37:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Dstamp

Pages: 1
General Mach Discussion / Import dxf not in 'File' drop down menu
« on: May 20, 2013, 11:05:36 AM »
I only have;
- load gcode
- lazy cam
- entib
- close files
- exit

Do I have to load a plugin or wizard or something else?
The manual in section 8 indicates I need to go to load file import dxf,  but don't have that option, 

Any ideas out there?

Machine runs fine,  wizards and all else that I have tried works ok but no dxf.

Please help,



General Mach Discussion / Need help with Viper servo drives
« on: December 27, 2012, 07:40:25 AM »
I have been converting a YCM-30 and have reached the point of testing the encoders (US Digital E5 1000 CPR no index) but cannot get anything but 0000 from the M command in hyper terminal.  Upon investigation, I discovered 5v from the power supply pin (to the encoder) but also by accident about 4.6v on each of the A,B,A-,B- also (which definitely doesn't seem correct).  Anyone that can check their cards for this condition I would surely appreciate. 

I only have a few more days to be able to work on this conversion before I travel again for work, so any help right away would be greatly appreciated.  I called Larry Kenny but I think he may be off for the holidays.

Best regards,

Daryl Stamp

Pages: 1