Messages

391

Show"N"Tell ( What you have made with your CNC machine.) / First Litho LED Frame

« on: December 27, 2012, 10:06:19 AM »

How did the reveal go?

392

Show"N"Tell ( What you have made with your CNC machine.) / Laser cut titanium handcuff ring

« on: December 23, 2012, 09:45:20 AM »

I want that airplane flight security ring knife survival tool! Great work.

393

General Mach Discussion / Mach3 stuck

« on: December 23, 2012, 09:39:13 AM »

Dump and reinstall.

394

Newfangled Solutions Mach3 Wizards / Newfangled wizards for Mach4

« on: December 18, 2012, 10:34:35 PM »

It looks great!

395

General Mach Discussion / how to setup the steps per unit in config->motor tuning

« on: December 18, 2012, 05:12:22 PM »

Why not set it up at 25Khz?
   IIRC, Doesn't a 1/4-20 travel 1" in 5 turns? If so.
200 x 8 x 5= 8000.

396

General Mach Discussion / Mach 3 Lathe setting up tools and offsets. hair already gone...teeth next...

« on: December 15, 2012, 08:53:54 PM »

Do it by touching off each tool to a piece in the chuck of a known diameter.

397

General Mach Discussion / Mach 3 Lathe setting up tools and offsets. hair already gone...teeth next...

« on: December 12, 2012, 08:04:51 AM »

If Lupe parked on the 50 yard line. Never mind I didn't understand it either when setting it up the first time. I am still vague though I do get it right eventually. IIRC don't you use the "ref" for the first or master tool and then just save for all the rest of the tools?

398

Promote and discuss your product / Five year anniversary contest from Soigeneris.com

« on: December 04, 2012, 08:56:04 AM »

Hopefully with many more years to come! Congrats on the success. Good quality, advice and service will do that.

399

General Mach Discussion / Help with setup & controler

« on: December 01, 2012, 11:20:54 AM »

I have read of a few errors of loss of position due to an extremely hot environment for the G540. Definitely a fan and or heat sink.

400

General Mach Discussion / BT30 spindle from scratch - with power drawbar and ATC of course

« on: November 27, 2012, 09:43:49 PM »

Nice work Ray! Looks like it is working very well.