Messages

371

General Mach Discussion / Ref All Home does not work

« on: July 23, 2013, 10:20:16 AM »

The debounce worked, Was set to Zero (default?).
Tried 2000, changed down to 1000, all good.

What is the recommended debounce setting?

Many thanks

Drew

The smallest number you can get away with. The longer the debounce, the farther the axis travels til the signal is seen.

372

General Mach Discussion / Limit switches

« on: July 11, 2013, 10:43:58 AM »

There is plenty to understand there! Is there something in particular you are having an issue with or difficulty comprehending?

373

Show"N"Tell ( Your Machines) / Dyna Myte 2400

« on: July 06, 2013, 03:25:26 PM »

There should be a few around. Personally I don't remember what I did with mine. Hopefully someone here will chime in. Sent the manuals this afternoon.

374

Show"N"Tell ( Your Machines) / Dyna Myte 2400

« on: July 03, 2013, 09:13:59 PM »

Pm me your email address. I have the service and operation manual. I also have a copy of dynacom.exe

375

General Mach Discussion / Re: Homann DC04? Threading with pics

« on: July 03, 2013, 10:09:07 AM »

Rich, I was just rereading this thread and realized you asked this question years ago and I never responded. The literature was not difficult to read, it was and is difficult to comprehend. Two different problems entirely, one for which you can not be responsible, me. ;-)

376

G-Code, CAD, and CAM discussions / All Dressed Up & No-Where To Go?

« on: June 13, 2013, 03:25:08 PM »

CamBam is easy to use and affordable also.

377

Show"N"Tell ( Your Machines) / Many many inputs

« on: June 13, 2013, 12:07:01 PM »

The PMDX 126 is a great unit too. It allows the SS to plug in directly. It has expanded mode capabilities that allow more inputs on a single port if desired. It has plenty more abilities I don't even begin to understand ;-)

378

General Mach Discussion / Re: Tolerance puzzle.....

« on: February 20, 2013, 02:47:52 PM »

Why be embarrassed? I would use a dial indicator myself.

379

General Mach Discussion / Tolerance puzzle.....

« on: February 20, 2013, 08:46:29 AM »

Climb or conventional cut?

380

General Mach Discussion / Tolerance puzzle.....

« on: February 20, 2013, 08:45:28 AM »

Which axis is showing the variance or is it both? If it is just 1 axis. I would think it is an axis calibration or backlash compensation value error.