12
« on: March 18, 2009, 05:42:15 PM »
I am new to these types of forums, and experiencing great difficulty navigating them. Anyway here goes. I own a medium size milling machine. It had Anilam controls Crusader II to be exact. They went out and I decided to try a pc control. I went with Cam soft and the Galil control basically because the support for Mach was so hard to get to. Everything was going fine till I lost the dongle. I want to proceed with Mach software using the Galil control. Heck if a person can configure one of those he can figure out how to use this forum. so far all I have figured out is how to reply. There seems to be no clear path to a post new button.
I also have a couple of lathes that will be next. 3 in fact 2 are stepper with an open loop system. One is a high end Emco Mayer commercial cnc with Seimens controls. Where is the best place to get step by step instructions to begin. Thanks in advance.
Jimmy Haskins
San Antonio Texas