Messages

31

General Mach Discussion / Re: Is it possible to turn the screen display 180 degrees?

« on: May 15, 2009, 02:18:01 AM »

If you look at the mill as having a stationary table and all movement as done by the quill does the quill follow the display?

32

General Mach Discussion / Re: hole macro help please :)

« on: May 14, 2009, 05:38:55 PM »

What happens if you write a short G code program with the M98 call?

33

General Mach Discussion / Re: Problem configuring ncpod

« on: May 14, 2009, 05:17:21 PM »

I would un install Mach3 and any NC POD drivers. Re install Mach3 without the parallel port driver. then install the NC POD drivers.

34

General Mach Discussion / Re: Problem configuring ncpod

« on: May 14, 2009, 03:59:40 PM »

You might also get some help here

http://www.machsupport.com/forum/index.php/topic,2174.40.html

35

General Mach Discussion / Re: Problem configuring ncpod

« on: May 14, 2009, 03:53:46 PM »

Take a look at this link

http://www.machsupport.com/forum/index.php/topic,2209.0.html

36

General Mach Discussion / Re: Problem configuring ncpod

« on: May 14, 2009, 03:34:32 PM »

Sorry, I have no experience with NCPOD.

37

General Mach Discussion / Re: Problem configuring ncpod

« on: May 14, 2009, 03:10:22 PM »

You need a "Plug in" for Mach3 to use the USB port.
Try this one.

38

General Mach Discussion / Re: Problem configuring ncpod

« on: May 14, 2009, 01:40:11 PM »

You have not set any pin numbers for step and direction.

39

General Mach Discussion / Re: hole macro help please :)

« on: May 14, 2009, 12:10:46 PM »

Just a WAG but try putting a space between M98 and (femhole.nc).

40

General Mach Discussion / Re: hole macro help please :)

« on: May 12, 2009, 04:15:19 PM »

You could, but why not just do it in your part file?