Guest
Show Posts
1
General Mach Discussion / Mach3Turn corrupting g-code after RESET is pressed
« on: February 19, 2009, 04:48:43 AM »
Hi!
I have installed the demo-version to test Mach3 and I have a strange problem in Mach3Turn.
If I start Mach3Turn and load a g-code file everything looks ok. I can hit regen and no problems. I can scroll throuh the g-code file, about 300 lines.
If I then press RESET and press regen, the g-code gets corrupted. If I scroll the g-code-window after line 150 everything i messed up and the last line(s) just keep repeating.
This problem only occurs when the puls-driver is installed. I have tried to reinstall the whole operating system. XPsp3. It is the same problem with different gcode-files. 150 lines ok.
I have installed the demo-version to test Mach3 and I have a strange problem in Mach3Turn.
If I start Mach3Turn and load a g-code file everything looks ok. I can hit regen and no problems. I can scroll throuh the g-code file, about 300 lines.
If I then press RESET and press regen, the g-code gets corrupted. If I scroll the g-code-window after line 150 everything i messed up and the last line(s) just keep repeating.
This problem only occurs when the puls-driver is installed. I have tried to reinstall the whole operating system. XPsp3. It is the same problem with different gcode-files. 150 lines ok.