Messages

21

General Mach Discussion / Re: Configuration help

« on: February 16, 2009, 09:17:26 PM »

I found the problem. I followed the instructions and it all seemed to funstion, then the Y just stopped doing anything. I thought I had screwed up the config. Tried everything, Y would not move. Then yesterday I found the set screws on the Y shaft gear were not tightened up and that was the only problem. I had done it correctly. It seems to be dialed in now, Going to tram in the head tomorrow and then TRY and learn some g code and make something. Thanks for your help...............

22

General Mach Discussion / Configuration help

« on: February 14, 2009, 09:41:03 PM »

I am totally new to all of this. I have read and tried to get it right but something is wrong. What is the right numbers to set on the input and output to get started? I have a new Townlabs Mill and anxious to make it run. TYIA. Ussca.................