31
General Mach Discussion / Re: Help with verify button
« on: March 09, 2009, 08:49:41 AM »
Hi Bob
Thanks for your speedy reply, my problem is not with the column being out of square, ( though it was when I first had the machine).
What happens is I am cutting the outside of a rectangle, the Z axis puts on a 1mm deep cut and goes around the outline, when it comes around to put on the next 1mm cut depth it is about .1mm short of the first position, so when it goes up the right hand side it takes its new 1mm cut, but it also takes a .1mm shave off of the first cut! so making this side smooth. Then when it comes down the left hand side it is .1mm away from the first cut edge hence the steps.
I really need some help with the Verify command, as I am sure it is not working as intended on my machine.
Thanks again
RonC
Thanks for your speedy reply, my problem is not with the column being out of square, ( though it was when I first had the machine).
What happens is I am cutting the outside of a rectangle, the Z axis puts on a 1mm deep cut and goes around the outline, when it comes around to put on the next 1mm cut depth it is about .1mm short of the first position, so when it goes up the right hand side it takes its new 1mm cut, but it also takes a .1mm shave off of the first cut! so making this side smooth. Then when it comes down the left hand side it is .1mm away from the first cut edge hence the steps.
I really need some help with the Verify command, as I am sure it is not working as intended on my machine.
Thanks again
RonC