Hello Guest it is March 28, 2024, 06:05:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sawdustman18

Pages: 1 2 »
1
SmoothStepper USB / a axix does not respond with smooth stepper
« on: February 29, 2012, 11:54:16 AM »
upgraded to smooth stepper followed all directions and not the a axis does not respond all others do if I switch back to the port they all move fine.  It is a warp 9 smooth stepper.

2
General Mach Discussion / Re: Help with Auto tool zero macro?
« on: February 05, 2010, 01:31:28 AM »
I am running it on both one has the driver installed and the other is not.  both computers are vista if that matters.  I was planning to try it on an old xp computer that I have to see if that works.I have my probe on active hi and I am running 5volts to the mill and a probe lead.  Does it matter how the digitize light is lit?  I was thinking that if it can be emulated that how it lights should not matter.

3
General Mach Discussion / Re: Help with Auto tool zero macro?
« on: February 04, 2010, 01:34:49 AM »
Greg

I have a legacy cnc machine and it has it's own profile with the xml below.

Steve

4
General Mach Discussion / Re: Help with Auto tool zero macro?
« on: February 03, 2010, 10:33:23 AM »
Greg,

I am not all that savvy with computers how do I post the XML.  Also I have a legacy version of the software and there are 2 XMlL files do you want them both.

Steve

5
General Mach Discussion / Re: Help with Auto tool zero macro?
« on: February 03, 2010, 01:30:26 AM »
Greg,  The probe does not stop the movement with a manual input either.

Steve

6
General Mach Discussion / Re: Help with Auto tool zero macro?
« on: February 02, 2010, 03:20:24 PM »
I am using LPT

7
General Mach Discussion / Re: Help with Auto tool zero macro?
« on: February 02, 2010, 01:30:32 AM »
The digitize light on the diagnostic screen lights when the probe touches the router bit.

8
General Mach Discussion / Re: Help with Auto tool zero macro?
« on: February 01, 2010, 02:52:22 PM »
Can anyone help me.  When I give the code g31 z-3 f5 the router moves but when I touch the probe to the bit the probe lights but the z movement does not stop.  It does not stop when it gets to -4 either I have to hit the stop button.

9
General Mach Discussion / Re: simulate probe
« on: February 01, 2010, 09:39:11 AM »
also I used a hot key "p" and when I press it nothing happens no digitize light or any other reaction.

10
General Mach Discussion / Re: simulate probe
« on: January 31, 2010, 04:05:27 PM »
when I give the g31 comand the probe won't stop it.  The probe light is lighting but it just keeps going.  Any help with this?

Pages: 1 2 »