11
Tempest Trajectory Planner / Re: Tempest Planning - Preliminary information and testing
« on: September 26, 2009, 08:32:24 AM »
Hi Art,
this looks like an interesting project - you never could resist a challenge !
anyway, I tried it on my router;
first thing I did to check everything was still operational was to jog the x and z axes away from zero, then pressed GoTo Zero.
This caused squealing motors, but strangely the DROS showed X,Z at zero but the AAxis at approx 30, I tried it a couple more times with similar results, just different values of A....
regards,
Rab
CNC Toolkit - Free, Open-Source 5-axis CAM
http://www.cnc-toolkit.com/
this looks like an interesting project - you never could resist a challenge !
anyway, I tried it on my router;
first thing I did to check everything was still operational was to jog the x and z axes away from zero, then pressed GoTo Zero.
This caused squealing motors, but strangely the DROS showed X,Z at zero but the AAxis at approx 30, I tried it a couple more times with similar results, just different values of A....
regards,
Rab
CNC Toolkit - Free, Open-Source 5-axis CAM
http://www.cnc-toolkit.com/