Hello Guest it is March 28, 2024, 12:31:08 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - NeoTO

81
Mach4 General Discussion / Re: Pokeys57CNC and probing
« on: July 21, 2016, 12:08:34 PM »
The external pull-up on v1.2 boards is not required.

Are you able to replicate the issue with probing? We are testing it now and can't make it fail.

82
Mach4 General Discussion / Re: Pokeys57CNC and probing
« on: July 21, 2016, 11:54:17 AM »
Hi, guys

We haven't been checking the Mach4-related forums...

Can you please let us know which Mach4 plugin version you have been having problems with probing? We fix some early bugs a while ago and are eager to know whether anybody is still having issues with it.

* early PoKeys57CNC boards (v1.0 and v1.1) required an external pull-up resistor to be added to the probing input due to a hardware bug.
* pin 17 should be selected as probing input with invert option enabled. This should also work with simple contact-based probes.

Regards,
Matevž, PoLabs

83
We have just uploaded a new 'beta' release of the PoKeys software and plugin. The code in the Mach3 plugin was reorganized, which should now avoid problems with FRO.

84
PoKeys / Re: Problem with 0-10 V analog output VFD control
« on: July 20, 2016, 12:45:47 AM »
Can you try disconnecting the axes from PoKeys57CNC and observe whether the same behaviour is observed?

85
PoKeys / Re: Problem with 0-10 V analog output VFD control
« on: July 19, 2016, 08:01:44 AM »
Do you have GND and GNDi (isolated GND) connected? If these are connected, there is no galvanic isolation.
However, if you have those separate (as intended), did you measure the output voltage between the 0-10V output and the GNDi points?

86
PoKeys / Re: Problem with 0-10 V analog output VFD control
« on: July 19, 2016, 06:51:09 AM »
Did you move the power supply selection jumper to external power supply position?

87
PoKeys / Re: Problem with 0-10 V analog output VFD control
« on: July 19, 2016, 05:23:27 AM »
How do you power the PoKeys57CNC board?

88
PoKeys / Re: Soft limits enable Auto limit override
« on: July 18, 2016, 03:55:54 PM »
Manual limit override in Mach3 should temporarily disable the limits. We will check this.

Matevž, PoLabs

89
We will take a look and let you know.

90
PoKeys / Re: 57CNCdb25 Fast_USB Driver Not installing for Mach4
« on: July 08, 2016, 02:09:53 AM »
We updated the PoKeys57CNC and PoKeys57CNCdb25 devices homepage to include links to related content.

See here: https://www.poscope.com/PoKeys57CNCdb25 and https://www.poscope.com/PoKeys57CNC