Hello Guest it is March 29, 2024, 09:12:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johnv

Pages: « 1 2 3 4 5 »
21
General Mach Discussion / Re: Why doesn't OEMCode 307 jog?
« on: May 17, 2010, 04:39:36 PM »
Thanks again Hood! You've saved me 6 OEM Hotkeys. Thanks
Johnv

22
General Mach Discussion / Why doesn't OEMCode 307 jog?
« on: May 17, 2010, 03:23:17 PM »
Hi All,
I want to add some switches to my control panel to jog X, Y, & Z axis similar to the lower buttons in the (tab) MPG Mode screen. Using OEMCode 307 for X+, when I push my X+ switch, the X stepper runs continuously and doesn't stop when I release the button. The Jog Mode in in Cont. Can anyone explain what I am doing wrong?.
Johnv

23
General Mach Discussion / Re: Input or output
« on: May 12, 2010, 07:24:47 PM »
HI.
How does Mach3 handle the fact that the Reset button alternates red & green when at fault, but a solid green when reset or enabled?
johnv

24
General Mach Discussion / Re: Input or output
« on: May 11, 2010, 04:19:20 PM »
Thanks Hood!  I'll give it a try..... Works like a charm. Still having a problem with getting a remote Led to follow the page 1 Reset LED.
Johnv

25
General Mach Discussion / Input or output
« on: May 11, 2010, 03:35:18 PM »
Hi All,
I'm trying to get an external switch to trigger OEMCode 327 (Select MPG Jog Mode). Should I be using an input or output?
Johnv

26
Hood.... Thanks so much. I am using Output1, but I was able to change it to Output2, which I'll configure after I take the Mrs for a bit of Dinner. Thanks again
Johnv

27
Port 1 output 16 or input 13. I didn't know whether it required an output or an input. is the code 800?

28
Thanks for the reply Hood, I haven't had much luck modifying brains no less building new ones. Can you help please........PLEASE?

29
Hi All,

I added a RESET (Program Run screen) pushbutton on my control panel enabling me to RESET from my panel instead of my PC.  I now would like to add an led to duplicate the status of the RESET led. Can anyone help?

Johnv

30
General Mach Discussion / Re: 2nd parallel port pin (2-9) as inputs
« on: April 30, 2010, 07:41:41 PM »
Hello to you all,
 I'm using the same SIIG card and can't get ports 2-9 to work as inputs. all signals go thru the breakout board correctly to the db25 connector. I know that by not connecting the PC to the BOB. When I connect the PC, Mach3 puts pins 2-9 at a high level killing the signal. it keeps the other inputs at a low level allowing those to function. Any help out there? PLEASE!
Johnv

Pages: « 1 2 3 4 5 »