Hello Guest it is March 28, 2024, 03:59:27 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - compmedic

Pages: « 1 2
11
Right now im not using anything special code or generator. Im justing loading the sample G-code "roadrunner" to test.
I just played with the settings and was able to make my table bigger or adjust them to where the roadrunner is on the table but i loaded some other samples and they were way off. Plus i forgot to mention sometimes (depending on my settings) my machine tries to go further than what it can.

12
I have a Zenbot router with a xylotex controller but im having a few problems. As far as i know i have all the pins set-up correctly.
I can jog around with it. But when i load a part file then the part picture is off to the side of my table outline. See Example.
Also i need help with touching off my tools or something because my z axis doesnt come down while running and the tool is off table a little bit.
Please Help!!!!!!!!!!!!!!!!!
Im dying to start using this machine. Over-excited you could say.


Thanks for any and all support.

Darren

P.S. I forgot to mention that the machine does not have limit switches. I might need help with homing.

13
Hello All! Im Darren, im 32 and i reside in Missouri. I just recently purchased a Zenbot with xylotex controller and 24v power supply.
I have always been interested in cnc and will start this janurary for a 1 to 2 year certificate in machining. I plan on purchasing a sieg x2 mill in the future and converting it. I might even try to build my own router. I look foward to posting in the forum.

Pages: « 1 2