Hello Guest it is March 29, 2024, 06:16:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sledrat

Pages: « 1 2 3 »
11
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 07:38:40 PM »
sorry i mean machine

12
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 07:38:05 PM »
be carful i dont want your mach to crash
what mach are you running

13
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 07:31:46 PM »
the onle changes i made to it were information on tool changes and i changed m6 to m06 to get the mach to try to fake a tool change
the m6 to m06 did not help
in 1 crash the machine stoped then after about 5 seconds it started to move the z twards the table at a verry slow rate of about 3 in per min

14
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 07:26:46 PM »
the xml file you request is in the shop and im not there rite now
im not even sure how to acess it or how to coppy it to a mem stick
how could i view it and what should i look for??
i am not to schooled on the inter workings of all this new tec
i am still in the learning stage and man i have a lot to learn

15
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 07:21:33 PM »
here is another try to show you thi file im trying to run

16
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 07:08:06 PM »
hey i just tried to post the file
the fourm said to many char
the prog is abou 6000 lines long

17
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 07:01:06 PM »
i will try in a few min.

18
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 06:53:01 PM »
i dont know how

19
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 06:16:17 PM »
e stops are not limit switches
not getting e stop errors at tool change i get an emergency once in a while but the machine has already stopped

20
General Mach Discussion / Re: long program glitch
« on: December 06, 2009, 06:08:53 PM »
i have tried that to no resolve

Pages: « 1 2 3 »