Messages

31

Brains Development / Re: Howto send DRO Axis information?

« on: October 20, 2010, 11:31:49 AM »

this is solution.
we can send each axis via modbus with 4 register(4 byte)
2 byte for int and 2 byte decimal
up 65536.65536
i think is enough

Amir

32

Brains Development / Re: Howto send DRO Axis information?

« on: October 19, 2010, 05:13:47 PM »

i sent DRO position via macropump and serial port on Lcd.
but i decide use Modbus ,similar "jimmybondi"
Please explain .this thread remained without conclusion.


Amir

33

Show"N"Tell ( Your Machines) / Re: Just got a lathe to retrofit

« on: September 24, 2010, 08:22:18 AM »

very interesting.
 i dont work Until now with lathe but i think is very different .
thx

Amir

34

Show"N"Tell ( Your Machines) / Re: X machine-Like

« on: September 24, 2010, 08:15:04 AM »

After a long time ,Update
spindle build ER25 with 3 PFI ballbearing.
i use 2:1 pully between motor and spindle.about 6500RPM.


Amir

35

Show"N"Tell ( Your Machines) / Re: 1987 Bridgeport Production Center Interact 412 to Mach3 Conversion

« on: September 21, 2010, 11:37:20 AM »

cooooooool

Amir

36

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: September 15, 2010, 05:07:30 AM »

very interesting.

Amir

37

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: September 15, 2010, 02:19:12 AM »

or used ones from:
http://www.europalaserboerse.com/eng_product_catalog.php

in this site there are many secondhand machine for laser.

Many times, has been looking to build a laser machine for marketing marking textile(jeans , cotton ...)
i share my information with Tweakie But my information is not enough.

Amir


EDIT: For Spelling by Budman68 at the request from Amir (manmeran ).

38

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: September 14, 2010, 05:29:05 AM »

hi Tweake,

is it possible tell about ballscrew use in X axis ?
pitch?
4500mm/min is very good .

Amir

39

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: September 14, 2010, 05:04:51 AM »

coooooool

4500mm/min

Do you build another machine ?


Amir

40

General Mach Discussion / Re: Trouble on Z axis value

« on: September 14, 2010, 04:56:02 AM »

check your scale in axis