Messages

221

General Mach Discussion / problem by Torch ON and OFF

« on: May 10, 2010, 02:23:13 AM »

 hi all
i use mach3 with THC(In addition Sheetcam) for plasma machine.

when i run code(by CycleStart),Z Moves down to trig switch float, and Z=0 and code start, Consider We cut form a Square. now run code.Quarter cut will, and we press key STOP, here X & Y & Z is stop and TORCH IS OFF, now we again press cycle start ,my problem is : code Continues BUT TORCH NOT ACTIVE.

Please guide how the torch is automatically turned When Again the cycle button is pressed.

222

General Mach Discussion / Re: MACH3 is reassigning motor pins by himself

« on: September 06, 2009, 05:01:25 PM »

If you can try different version

223

General Mach Discussion / Re: MACH3 is reassigning motor pins by himself

« on: September 06, 2009, 04:43:47 PM »

I think you are using crack version
not sure.

224

General Mach Discussion / Re: DRO display

« on: September 02, 2009, 04:02:25 PM »

I was successful

225

Modbus / send DRO to LCD

« on: August 26, 2009, 12:27:53 PM »

please help me
http://www.machsupport.com/forum/index.php/topic,12430.0.html

226

General Mach Discussion / Re: DRO display

« on: August 26, 2009, 11:59:16 AM »

http://www.artsoftcontrols.com/MachCustomizeWiki/index.php?title=Axis_DROs_and_other_info._on_ModIO_LCD
please help me.

227

General Mach Discussion / Re: DRO display

« on: August 25, 2009, 12:59:44 PM »

I know that the exchange must send the requested slave to master then master response
How can this communication explained by the brain between master(pc) & slave?

228

General Mach Discussion / Re: Confused in Mach 2 enable pins config,it's mapping to XYZ or not?

« on: August 25, 2009, 05:19:11 AM »

I solve this problem with microcontroller

229

General Mach Discussion / DRO display

« on: August 25, 2009, 04:41:39 AM »

I have decision to show DRO information on LCD screen by using microcontroller and modbus
I have studied PDF files of MODBUS protocol
& also I have enough knowledge about microcontroller  AVR.
Please explain me the structure of this job by using brain

230

General Mach Discussion / Re: Confused in Mach 2 enable pins config,it's mapping to XYZ or not?

« on: August 04, 2009, 08:05:30 AM »

Thanks anyway.
It seems that I dont have access to STEP and DIR signals in VB
http://www.machsupport.com/MachCustomizeWiki/index.php?title=VB_Constants_for_Signal_Names
is that true?

or if not how can i access them