Messages

211

General Mach Discussion / Re: Three LPT Ports

« on: May 20, 2010, 05:13:47 AM »

you must use modbus for Handheld Pendant

212

General Mach Discussion / RUN REVERSE, Serious problem

« on: May 20, 2010, 02:07:28 AM »

i do , Z goto up and Z-safe is off.
Very strange.

amir

213

General Mach Discussion / Re: RUN REVERSE, Serious problem

« on: May 19, 2010, 02:00:44 PM »

this is exactly my problem

214

General Mach Discussion / Re: change Z position

« on: May 19, 2010, 10:54:01 AM »

no, reverse run work well

215

General Mach Discussion / change Z position

« on: May 18, 2010, 01:21:12 PM »

i load "Z change.tap" to mach3 and it run( i use sheetcam) , then in line 30 , i press "Feed hold" then "Reverse run". Is apparently no problem but issue is Z .
 i see when go reverse, approximately When reach to line 29 . is Z dro changed .
is very bad.this is big problem.
Z dro goto 52 and plasma dont work and dont cut.
Please guide me .

216

General Mach Discussion / Re: Emulated Inputs

« on: May 16, 2010, 03:18:32 AM »

i think you setup switch Y for Axis X and switch X for Axis Y.

217

General Mach Discussion / Re: reverse run

« on: May 13, 2010, 03:33:22 AM »

yes Hood.
but :
http://www.cnczone.com/forums/showthread.php?t=103133
this is a problem almost for all

amir

218

General Mach Discussion / Re: reverse run

« on: May 13, 2010, 03:02:25 AM »

Why none of the Moderators do not respond?
This is an important.
My idea for "PAUSE".
When the pause button is pressed, for example the middle of a line, continue program to end line ,then act Pause button .
This idea is not lost no step.
Whether it is feasible ?

219

General Mach Discussion / Re: reverse run

« on: May 12, 2010, 11:14:31 AM »

no body ?

220

General Mach Discussion / Re: reverse run

« on: May 11, 2010, 04:32:01 AM »

hi Guys
recently i use plasma and I very much need use reverse run. i read much post in net, and
I reached the conclusion that : "reverse run dont work very well"
Beforehand, I apologize for judging If incorrect.
If we use run reverse, we will not be lost step  

thx
amir