Hello Guest it is December 06, 2021, 10:08:07 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - manmeran

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 »
181
G-Code, CAD, and CAM discussions / Re: Using a Variable
« on: May 25, 2010, 01:49:41 PM »
what version of MACH are you running?

182
thx for information

183
General Mach Discussion / Re: RUN REVERSE, Serious problem
« on: May 25, 2010, 12:57:07 PM »
i think find problem :

Code"G0 X#602 Y#603"   'Return To Stop Point
and
Code"G28.1 Z0.500"    'ReREF Head  to TOM

184
Brains Development / new button
« on: May 25, 2010, 12:51:05 PM »
i create two new button in Screen.
and i should can Through modbus have access.
Is it possible through the brain to activate these two button ?

185
I think you use servo motor for Spindle.
Constantly moving, does not hurt to Servo motor?

186
General Mach Discussion / Re: RUN REVERSE, Serious problem
« on: May 25, 2010, 02:23:19 AM »
thx for try
i attach .XML  .SET and .tap

BR549 -
what version of MACH are you running?
i want use it version
and video in vimeo:
http://vimeo.com/11992679

187
General Mach Discussion / Re: RUN REVERSE, Serious problem
« on: May 24, 2010, 03:31:05 PM »
very thanks for help
i use mach3 VER 3.042.020 +sheetcam G31 +THC

are you do test my code on your PC .?
not problem ?

188
General Mach Discussion / Re: RUN REVERSE, Serious problem
« on: May 24, 2010, 02:54:14 PM »
i test without feedrate  but result is same.
i do manually this macro , all thing is ok( i mean : first pause then stop  then "SET NEXT LINE" and start)
but when i run macro with button ,feedrate change
i was crazy.

189
General Mach Discussion / Re: RUN REVERSE, Serious problem
« on: May 24, 2010, 02:13:28 PM »
then i must delete it and again do test?
in addition attach my .SET

190
General Mach Discussion / Re: RUN REVERSE, Serious problem
« on: May 24, 2010, 02:04:47 PM »
Please guide to get the desired result.
are you test my attach ?  
are you use sheetcam?  if yes  which post processor ?

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 »