Messages

141

VB and the development of wizards / Re: start from line #

« on: June 02, 2010, 04:27:40 AM »

As far as I know ,1300 ms is for my macro(M115) ,not macropump.
is it important that there is macropump what code to run?

142

General Mach Discussion / Re: Z Axis Ball Screw Pitch

« on: June 01, 2010, 03:47:43 AM »

then your drive is digital .but i have Yaskawa(analog, SR15BC)
them are Speed control. for cnc machines are suitable?
in addition ,SmoothStepper can drive them ?

Amir

143

General Mach Discussion / Re: External Button for Auto Tool Zero

« on: June 01, 2010, 01:46:54 AM »

This problem is not in plasma. General case.

Can you trigger the macro with an onscreen button during a cut?

yes, i can with button and no problem even during cut

Is there noise swamping the input while plasma is running?

no, i dont test this Steps with machine. i test only with PC but when i run code ,Trigger does not cause to activate macro
If possible please test my file on the your PC.
may I get wrong step.
again thx.

Amir

144

General Mach Discussion / Re: New PC Loosing Steps (I think)

« on: May 31, 2010, 02:35:23 PM »

thx.
very good

145

VB and the development of wizards / Re: start from line #

« on: May 31, 2010, 01:31:44 PM »

in fact C & D sense "M03" .have You a better suggestion ?

are you have ?

AND

when i trigger "INPUT#1" ,dont trigger M115.

146

VB and the development of wizards / Re: start from line #

« on: May 31, 2010, 01:26:40 PM »

no.
you dont understand my mean.
in cutting with OXY/fuel Sometimes Because to being dirty sheets ,cutting surface is not well done. The user can then once again previous path from starting point to begin Counter

does not Any interference in the main process

147

General Mach Discussion / Re: New PC Loosing Steps (I think)

« on: May 31, 2010, 01:20:38 PM »

you must change your PC.
No need for change operating system .

148

VB and the development of wizards / Re: start from line #

« on: May 31, 2010, 01:14:43 PM »

dangerous  
why?

What is important for this forum:

when i trigger "INPUT#1" ,dont trigger M115.

149

General Mach Discussion / Re: External Button for Auto Tool Zero

« on: May 31, 2010, 10:52:48 AM »

Someone faced with this problem

150

General Mach Discussion / Re: Z Axis Ball Screw Pitch

« on: May 31, 2010, 10:44:58 AM »

2000 line encoder

are you use servo motor ?
if yes DC or AC ?
if you use AC ,SmoothStepper work well ?