Messages

131

VB and the development of wizards / Re: start from line #

« on: June 05, 2010, 06:54:05 AM »

Amir look in the MACH Macro Programmers Manual, Page 57. That will tell you what you need to know.

i think you mean is : If IsActive(INPUT1) Then
                             code" M..."
                             End If
i test it,no change Compared to previous test .
result is same

i think When the code runs not possible Execute macro with External Button.

132

VB and the development of wizards / Re: start from line #

« on: June 04, 2010, 01:56:20 AM »

thx Terry

133

General Mach Discussion / Re: External Button for Auto Tool Zero

« on: June 03, 2010, 03:48:59 AM »

i change OEMled to userled and invert signal.
result :
no change. actually it work well but only when code dont run( Axes are no moving )

134

General Mach Discussion / Re: External Button for Auto Tool Zero

« on: June 03, 2010, 03:37:19 AM »

thx Scott
i check it

Amir

135

General Mach Discussion / Re: Limit Switch Triggered without limit switches?

« on: June 03, 2010, 01:38:12 AM »

please send XML file

136

General Mach Discussion / Re: RUN REVERSE, Serious problem

« on: June 02, 2010, 03:21:30 PM »

when we use this Command (DoOemButton(285)    'Return to stop position)  on the page is displayed warning.Like the image below

I use modbus pendant and I dont want verified this warning as manually( Because I am away from PC) .
Is there a way that it does not show this warning?

Amir

137

VB and the development of wizards / Re: start from line #

« on: June 02, 2010, 11:09:34 AM »

why nobody can not help me ?
This problem is so big?

138

VB and the development of wizards / Re: start from line #

« on: June 02, 2010, 05:46:44 AM »

is it possible guide me more ?

139

VB and the development of wizards / Re: start from line #

« on: June 02, 2010, 05:26:50 AM »

you want to do is be able to run from the line where the latest M3 was and you want to be able to do that from an external button - correct?

exactly.
i not problem with my macro, it work well.
but my problem is External button.when code dont run and axis is Immobile,i can trigger macro with external button. but when i press "Cycle start" and code run ,Does not do anything right. i dont trigger macro with external button.
I hope you understand my problem
please see my screen
Amir

140

VB and the development of wizards / Re: start from line #

« on: June 02, 2010, 04:35:19 AM »

yes, i call m115 with macropump.
I think you mean is:
Process inside macropump with the code located in(M115) ,should not be more than 100 ms
SO What is the solution?