Hello Guest it is September 28, 2020, 07:03:10 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - drew

Pages: 1 2 3 4 5 6 7 8 »
1
I watched the video again
add no-op before lobe

2
ok i have been working on new brain
but cant seem to figure out to select several inputs for an And or OR lobe
I know i have done this before
can someone point the way
Thx Drew

3
Brains Development / Brain for air valve for machine that requires air
« on: March 14, 2013, 05:47:08 PM »
Ok so my HNC leaks air badly. I use a brain to open the air when ever the machine is running or spindle is on.
Also if I open/close collet do tool change or cutoff or jog. it uses the 'is running' as a trigger.
what i would like is for the air to stay on during and for 10-30 sec after any of these operations.
if you have any ideas please share them.
Thanks Drew

4
General Mach Discussion / Re: setting up tooltable
« on: February 28, 2013, 09:58:39 PM »
I think this is the correct link
My youtube is BurgmasterMill

http://www.youtube.com/watch?v=mIt4ieYpmvA

5
General Mach Discussion / Re: setting up tooltable
« on: February 28, 2013, 08:39:55 PM »
When it works right it will work till a reset or reference then maybe it still works right
 Maybe it doesnt

6
General Mach Discussion / Re: setting up tooltable
« on: February 28, 2013, 08:35:16 PM »
The x axis overtravles. The offset is set to 3.4 . Dro reads 6.8
It move 1 for 1 instead of .5 to 1

7
General Mach Discussion / Re: setting up tooltable
« on: February 28, 2013, 08:17:33 PM »
Its not changing by its self . I have chgd dia to rad to dia. That didnt help

8
CVI MachStdMill (MSM) / Re: not using master tool
« on: February 28, 2013, 03:08:32 PM »
ok thats what i thought

9
General Mach Discussion / Re: setting up tooltable
« on: February 28, 2013, 02:55:07 PM »
r3.043.062 machstdmill screen for lathe
i thought i was on to something that manual jog after zero return would fix this but not sure now.
I have got it to work correctly without reboot after  a zero return. sometimes after a reset and zero return it goes from working correct back to radius.

My lathe has done this for years. I was using an older ver of mach and a screen that was origanlly for a mill that i changed. I thought the screen was the problem. but i upgraded mach so i could use the machstdmill-lathe screen. this did not run well on my older PC so i had to upgrade it as well. the new PC has a low voltage pp which would not fire my ssr's . now i have a cnc4pc C11 also which is much better just the ssr's.

10
CVI MachStdMill (MSM) / not using master tool
« on: February 27, 2013, 05:14:15 PM »
I have read the manual but still didnt understand the master tool mode.
i dont think i have it turned on but i set it to 9 anyway my lathe has an  8 tool ATC.
I set the z to a common point for all tools and x on centerline then adjust WCS for where i want z on the workpiece.

Pages: 1 2 3 4 5 6 7 8 »