Hello Guest it is March 28, 2024, 05:28:15 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Belli

Pages: 1
1
Competitions / Re: ******Guess and win a G100 Grex******
« on: May 15, 2007, 04:14:20 PM »
Hi All,

If the figure is between 2 000 000 and 3 000 000 then it's got to be 2 500 000.

Keep my fingers crossed.

Greg ??? ??? ???

2
General Mach Discussion / File naming with Mach
« on: February 20, 2007, 05:00:31 PM »
Hello all,

I am writing a new screen for plasma, how will Mach know which macro folder to use? Do my .set .xml and macro folder all have to have the same name?

Second question, how will Mach know that it is a Plasma? I can't see a setting directly but I guess that if you have the correct controls enabled it will then be implicitly a Plasma?

How does Mach know to hold the G-code until the 'arc good' signal is received, I can't seem to find a function for this.

Thanks
Greg


3
Galil / Re: Mach3 + Galil
« on: January 24, 2007, 02:51:41 PM »
Hi Drew,

It's my understanding that Barry's plugin works with the 1800's (PCI) and that Art is busy with the 2100's (Ethernet) I don't think anyone is busy with a USB version.

Greg

4
Galil / Re: Mach3 + Galil
« on: January 21, 2007, 05:13:39 AM »
Hi Brian,

I am very pleased someone has taken the bull by the horns! ;D  I have a mill running a DMC1840 with JraCo software, the best words I can use to describe the software is 'functional'. I will try your plugin as soon as I have upgraded the PC in the machine (currently P2) and let you know how it goes. The JraCo software pre-processes the file to convert to the galil commands, takes about 3mins per 1000 lines of Gcode, if you make a mistake or have to restart it reprocesses the file everytime, very annoying! :(

Has an MPG been implemented with this plugin yet, this is a most useful feature.
Regards
Greg

www.cncdirect.co.za

Pages: 1