Messages

21

General Mach Discussion / Re: Help getting set up

« on: November 15, 2008, 02:42:06 PM »

No, I wont be using any pins for a spindle. I wouldnt think that would matter really to make the motors jog.

I am getting movement in the x and y when I jog with the key board, but no motor movement. My pulse frequency is 24060, if that means anything...

Also, I used aluminum wire to connect all the elcetronics, and the wire that is connecting the motors is copper... I wouldnt think that would make a difference, just FYI, I guess!

I will check again to make sure the direection and step are correct... and I will check the printer port again...

22

General Mach Discussion / Re: Help getting set up

« on: November 15, 2008, 01:42:47 PM »

My .sml file should be posted...

23

General Mach Discussion / Re: Help getting set up

« on: November 14, 2008, 10:55:46 PM »

Strange, I am having the same exact problem and have done the same things Beanprofit has done! hmmm...

I am not sure what an .xml file is, where to get it and save it... Im new at this. Can somone help me with that?