181
General Mach Discussion / Re: Sound Logic Encoder Interface anyone?
« on: December 28, 2006, 02:59:17 PM »
I'm thinking of putting Mach on a machine that will be cutting sink holes out in Granite counter tops, and there is no room for error. The machine will go slow 5-9 IPM while cutting so there will be enought time to hit the eStop but I don't want to stand next to it all day. I emailed Rogers a few times about board but didn't get a reply. I would like to test it! There is another person on the forum that has the board but didn't get it working right yet.