Hello Guest it is March 28, 2024, 05:30:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DennisCNC

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 »
151
I got me a cubloc also with the same proto board, thing is sweet! 

Wayne, will you want to share some of the code that you used for the LCD?

152
General Mach Discussion / Re: backlash compensation going haywire
« on: April 10, 2007, 06:15:26 PM »
I wounder if Art knows every trick about Mach3?  Almost sounds like the software evolves by it self!  What great software!!!!!!

Thanks  Art, Brian and the rest!!

153
General Mach Discussion / Re: backlash compensation going haywire
« on: April 09, 2007, 09:33:06 PM »
When you start your G code file does your CV light stay off?  Maybe the G code turns it on again.

154
General Mach Discussion / Re: backlash compensation going haywire
« on: April 09, 2007, 03:50:26 PM »
Are you in CV  (constant velocity)  mode?  If you are then turn it off for backlash comp to work.

155
There is probably noise on the step line or the PPort is 3.3volt instead of 5volt.  Are you using a breakout board or direct to the pc port?

156
Show"N"Tell ( Your Machines) / Re: Bridgeport Series 1 control panel
« on: April 08, 2007, 11:36:40 AM »
Like it a lot!!!

157
General Mach Discussion / Re: servo following error problems
« on: April 06, 2007, 07:44:38 PM »
^^ Then Ron has another customer!

158
General Mach Discussion / Re: servo following error problems
« on: April 05, 2007, 10:46:38 PM »
Do you have servos or steppers on you machine?  In the pictures you have steppers.  So now the encoder board is tracking the machine like it should?  I'm thinking of getting one also in a day or two.

Thanks

160
General Mach Discussion / Re: servo following error problems
« on: April 01, 2007, 10:31:12 PM »
golash,
 Any good findings to sort out the problem?

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 »