Messages

131

Promote and discuss your product / Re: Multifunction CNC Board

« on: July 25, 2007, 09:28:34 AM »

^^ This is a break out board not a stepper driver board.

132

Show"N"Tell ( Your Machines) / CamTech RM25 router with Mach

« on: July 23, 2007, 10:24:36 PM »

Here is the link:
http://www.cnczone.com/forums/showthread.php?t=40870

133

Show"N"Tell ( Your Machines) / Re: Glue dispenser CNCs

« on: July 22, 2007, 10:49:26 PM »

Thats it very nice!!  Put up a video when you get a chance.

134

General Mach Discussion / Re: limit switches

« on: July 16, 2007, 10:36:36 PM »

The switches will need a 5v supply.   Did you sent the correct pin numbers in the setup screen?   Do any of the led's in the Diagnostic screen change state when you push a switch?
Here is a link of how it is done:
http://www.solsylva.com/cnc/limits.html

135

Third party software and hardware support forums. / Re: 8 wires

« on: July 12, 2007, 07:26:16 PM »

You can start by connecting them bipolar half winding.  Take the A and A# on the motor and connector the same terminals on the drives and do the same with the B and B#. 

136

Show"N"Tell ( Your Machines) / Re: Help! Hardinge CHNC Retrofit

« on: July 11, 2007, 10:18:26 PM »

Scott, have you looked at Viper servo drives?

137

Show"N"Tell ( Your Machines) / Re: 5 axis Spinning Lathe: machine and control panel in progress

« on: July 06, 2007, 06:11:12 PM »

Looking good!!

What is the board that is circled on the picture?

138

General Mach Discussion / Re: Help...canned cycle

« on: June 30, 2007, 04:02:17 PM »

Use the multi-pass wizard in Mach3.

139

General Mach Discussion / Re: stuck on external estop

« on: June 30, 2007, 04:00:38 PM »

Go to the diagnostics tab and see if any inputs (little red lights on the right of the screen) are on.

140

Show"N"Tell ( Your Machines) / Re: Eagle KM-750..Anilam Crusader GX-M

« on: June 28, 2007, 08:35:49 PM »

Did you get to play with the Viper drives?