Hello Guest it is March 29, 2024, 07:39:36 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rabphxaz

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 »
81
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 06:09:43 PM »
sent to your email address

82
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 05:45:33 PM »
ok, i'll go get it.

83
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 05:38:05 PM »
ships pasing in the night again. i don't know what an xml is.

84
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 05:36:56 PM »
ok, i went to ports/pins, input signals, and i have enabled x++, x--, y++, y--, and z++, z--, all to port #1, pin #15. down further i see that Estop is enabled, but no ports or pins are chosen. in the Output Signals tab, i have output #1, port #1 enabled.

85
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 05:27:31 PM »
yes, i have the switches connected that way, and i have checked them for continuity. both that wire and the ground are continuous, and i can trip any limit switch to break continuity. so it may be that i have the bob wired correctly -- do you think that the mistake might be in the ports/pins section in mach3? i'm going to bring that up so i can refresh my memory on what i have done there, and report back.

86
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 05:16:23 PM »
the green wire that's next to them is the ground wire that i soldered to the ground prong of the 3-prong wall plug, and that is plugged into the house wiring. the other two wires in the plug are not connected to anything.

87
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 05:14:44 PM »
those are the limit switch wires - just think of each red/black combo as one wire.

88
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 05:13:46 PM »
the two wires that you see are actually one wire -- the shielded cable i used had the 2 red and black in it, and i soldered them together at every connection point.

89
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 04:57:56 PM »
thanks, they went out just a minute ago

90
General Mach Discussion / Re: ports and pins
« on: December 19, 2008, 04:47:12 PM »
our posts are passing each other in the ether, i think.

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 »