11
General Mach Discussion / Re: Circlular Pocket Problem and mach3 setup
« on: October 30, 2008, 03:09:56 PM »
Dear Graham ,
Thank you very much for your help through your email as well.
It was indeed the IJ mode I switched to Inc and it loaded perfectly!
The problem was it loaded other programs (linear pocket cutting) perfectly
but not on the circle pocket from inside to outside w overlap pocket cut.
Now everything is fine and Im up and running on my new miniCNC
Thank you again!!
Thank you very much for your help through your email as well.
It was indeed the IJ mode I switched to Inc and it loaded perfectly!
The problem was it loaded other programs (linear pocket cutting) perfectly
but not on the circle pocket from inside to outside w overlap pocket cut.
Now everything is fine and Im up and running on my new miniCNC
Thank you again!!