Hello Guest it is December 02, 2021, 02:03:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - stevec

Pages: « 1 2
11
General Mach Discussion / Re: Ignore Tool Change
« on: December 09, 2005, 10:52:05 AM »
Been there, done that.
Change settings and go to file exit. Open back up and no save for settings. I am using Version R1.83.030

12
General Mach Discussion / Ignore Tool Change
« on: December 09, 2005, 09:19:32 AM »
I am using Mach3 and am a new user. When I go to settings and unmark ignore tool change, all is fine until I shutdown. How do I make this stay off everytime I start up.


Pages: « 1 2