Hello Guest it is January 24, 2022, 11:34:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - skaha

Pages: « 1 2 3 4 5 6
51
Show"N"Tell ( Your Machines) / My setup
« on: December 18, 2006, 08:01:01 PM »
My first attempt.

52
General Mach Discussion / weird happenings
« on: December 18, 2006, 07:50:21 PM »
Hi, I have a hobby cnc pro rev 1 board running mach 3, I had everything running, limit and home switches working, shut down last nite, started up this am the z axis would not move only whirring sound, disconnected wires for z and wired them to x axis, worked fine, disconnected again and wired back into z, worked fine, hooked up original wires from x to x terminal, guess what, x axis now just whirrs but dos not turn. Any ideas besides garbage can?
Thanks
Terry

53
General Mach Discussion / Re: error report
« on: December 17, 2006, 07:42:39 PM »
Thanks guys for the help, I am using version 3 trial edition. I will watch the videos again, I suspect it is ok, I just have a large learning curve to get around.
Terry

54
General Mach Discussion / Re: error report
« on: December 17, 2006, 06:18:21 PM »
Thanks for the reply Chaoticone, I have my motors enabled and they all run in the proper direction including homeing, is there something in the outputs screen regarding motors I have missed?
Thanks
Terry

55
General Mach Discussion / error report
« on: December 17, 2006, 05:46:40 PM »
Hi, I am brand new to cnc, I have my machine built and have limit and home switches working properly, my question is why when I ask for a configuration test, it shows an error in output --no pins or ports selected, the only outputs I have enabled is for the pump signal and I have the proper settings set. Also what is the proper sequence to test the machine, I type in some g code in the mdi screen but when I switch to run screen, the code is not there. What am I missing?
Thanks for any help you can offer.
Terry

56
General Mach Discussion / Re: home switches
« on: December 15, 2006, 07:32:13 PM »
Thanks for the replies hood, no I guess I am not homing but moving the axis with the jog control, will try.

57
General Mach Discussion / home switches
« on: December 15, 2006, 06:47:10 PM »
Hi, I am new and just finished my desktop machine using a board from hobby cnc with an e stop addition, my limit switches are nc in series and by checking one of the axis in the pins input screen they work fine triggering an e stop, my home switches are nc hooked up individually to their own pin and activated in the above screen, when I manually push the home switches with the axis moving, nothing happens, the motor continues on. What am I missing? Any suggestions would be much appreciated.
Thank you.

Pages: « 1 2 3 4 5 6