Hello Guest it is March 28, 2024, 09:31:23 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 01sporty

Pages: « 1 2 3
21
LazyCam (Beta) / Drilling holes
« on: December 20, 2006, 10:57:40 PM »
OK, I know this must be simple but it's escaping me.  I have a dxf with two layers.  One layer has a the toolpath and one has holes to be drilled.  How do I drill the holes?  I've drawn the holes both as point markers and as circles and can't find the key to getting LC to drill them.
I'm using LC 2.635.
TIA,
Walt

22
VB and the development of wizards / ActivateSignal(OUTPUT1)
« on: December 12, 2006, 07:35:09 PM »
Hi All,

First post so I hope I'm in the right spot.

I'm in the rudimentary stages of setting up a G100 and wanted to write a few (what I thought would be) "simple" macros to control the outputs.

I first went into config/ports & pins/output signals and enabled output 1, 2, 3, and 4.  I set 1,2, and 3 active low, which on the G100, activates the LED's so I have 3 LED's on and 1 off.

I went to Notepad and put in the single line: ActivateSignal(OUTPUT1). I tried 2, 3 and 4 as well.  I saved it as M101.m1s. 

Needless to say, when run in Mach3, the G100 was unimpressed.  It sat there unblinking.  What am I missing??

Thanks,
Walt


Pages: « 1 2 3