Messages

21

Video P*r*o*b*i*n*g / Re: setting up cammera and laser

« on: December 04, 2007, 05:06:34 PM »

 Its hard enough to get a answer that is plane and to the point. To often poster try to make things harder than they need to be. When someone answers a post with wrong or misguided info it just makes it harder for folks that need an answer they can use. All I wanted to know was the placement of the laser in referance to the camera.
  Thanks
   Don

22

Video P*r*o*b*i*n*g / Re: setting up cammera and laser

« on: December 04, 2007, 11:06:44 AM »

 The example art shows is a line laser not a point laser. I have used David, and triangle and both use a line laser. I also own a nextengine 3d laser scanner. I think your confused and should find out what is correct before giving advice.
  I could not resist
   Don

23

Video P*r*o*b*i*n*g / Re: setting up cammera and laser

« on: December 03, 2007, 04:24:15 PM »

  I think the line should go across the tablle (from left to right) and the camera travels with the light from front to back. Correct or not?
   Don

24

Video P*r*o*b*i*n*g / Re: setting up cammera and laser

« on: December 03, 2007, 12:27:50 PM »

 Thanks for all your help.
    Don

25

Video P*r*o*b*i*n*g / setting up cammera and laser

« on: December 01, 2007, 02:00:33 PM »

 How is the camera to laser setup. Is the camera and laser running parallel to the X axis (X axis moving front to back (gantry)). What should the angle be of the camera and the laser. Is there any setup notes yet?
  Don