Hello Guest it is March 28, 2024, 01:14:27 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Don C

Pages: « 1 2 3 »
11
PoKeys / Re: Any one tried a MPG with the PoKeys?
« on: February 12, 2009, 07:05:39 AM »
 Thanks,
    Don ;)

12
PoKeys / Re: Any one tried a MPG with the PoKeys?
« on: February 11, 2009, 07:47:21 PM »
What MPG are you using with pokey55.
 Thanks
  Don :)

13
LazyCam (Beta) / lazycam in turn mode
« on: December 25, 2007, 12:08:04 PM »
 How do you get lazycam to cut a profile in more than one pass?
 Thanks
  Don

14
Video P*r*o*b*i*n*g / Re: MachCloud point viewer program
« on: December 17, 2007, 11:17:50 AM »
Thanks
  Don :)

15
Video P*r*o*b*i*n*g / Re: MachCloud point viewer program
« on: December 17, 2007, 08:58:01 AM »
 When I generate a point cloud it has a ( , ) between the code and the one with the hand doesn't?
  Don

16
Video P*r*o*b*i*n*g / Re: Driver Installation question
« on: December 08, 2007, 11:21:03 AM »
Thanks Art
 Don :)

17
Video P*r*o*b*i*n*g / Re: Driver Installation question
« on: December 07, 2007, 10:36:31 AM »
 Is there a way to zoom in on a scan. I seem to get a line in x,y,z plane. this is in mach cloud or is a way to rotate the scan.
 Thanks
   Don

18
Video P*r*o*b*i*n*g / Re: Driver Installation question
« on: December 07, 2007, 10:10:52 AM »
Thanks
  Don

19
Video P*r*o*b*i*n*g / Re: Driver Installation question
« on: December 07, 2007, 08:51:36 AM »
Art, If I leave the x at 0 it comes up with set less than 0.
 Thanks
   Don

20
Video P*r*o*b*i*n*g / Re: Driver Installation question
« on: December 06, 2007, 09:52:04 PM »
 I have the laser and camera mounted. I set the x to 1 & y to.01 stepovers.  I did the calibration and set the speed to 5. it has a good solid line red and white which changes as it moves. How do I get it to produce a file?
 Don

Pages: « 1 2 3 »