Hello Guest it is May 12, 2021, 05:54:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - bshaker1

Pages: 1
General Mach Discussion / Need help
« on: January 11, 2007, 06:41:50 PM »
All the part programs that I load into Mach 3 always come out to where the part is to small to see in the view window. The part is in a Shaded box with a yellow dashed border around it, the part is in the bottom left corner and I guess it's the machine cordinates in the upper right corner. If I were to run this on my machine the part would be way off the table(machines limits). What am I doing wrong.

General Mach Discussion / download problems
« on: December 24, 2006, 06:07:52 PM »
I saved mach3 ver2.0.009 update install onto my desktop, but when I go to install it keeps coming up with an error cannot decomprees setup program

Pages: 1