Hello Guest it is May 29, 2024, 05:28:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rcrabb

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 »
11
General Mach Discussion / Re: New to CNC with a problem
« on: January 18, 2010, 07:08:10 PM »
I would say its flex in the machine. Try cutting your square in the opossite direction and see if changes anything.

12
General Mach Discussion / Re: Sheet MEtal Bending with Mach3
« on: January 18, 2010, 03:03:56 PM »
Most Press Brakes ive seen have a mechanical stop for the hydraulic piston, not a limit switch. This stop is moved by a motor and the position is read on a dial. So bending a 90deg in 1/4" the stop would be set differently than a 45deg. Hydraulic presure would be the same.

13
Take a picture of the inside of the controller. Try to get good detail of the stepper drivers. Post the picture here and maybe someone can identify what would work best to get you going again.

14
Mach SDK plugin questions and answers. / Re: Wiimote plugin
« on: January 09, 2010, 10:41:06 AM »
Actually the wiimote uses bluetooth. The IR is used for tracking position on the TV screen. So you would need a USB bluetooth dongle if your PC doesnt have built in bluetooth.

15
Nice. I took a look and it seem easier than the other. Keep posting your progress. Im interested to see what you do with it.

16
Hopefully one of the experts can explain. My knowledge is very limited. I've been having great luck with the wizard.

17
I put the line several places in my code to test

18
Its different in 2008. I also tried it several ways in 2003 and no luck. Try the plugin wizard in 2008.NET

19
I put this line.

Kennedy::ManagedHooks::KeyboardHook^ keyboardHook = gcnew Kennedy::ManagedHooks::KeyboardHook;

Compiled with no errors


20
I'm no expert. I just have hundreds of hours learning c++ 2008.NET. I've run into many problems getting the wiiuse dll working with my plugin. I climbed that hill so hopefully I can help you.

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 »