Hello Guest it is May 26, 2024, 07:35:03 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Todd Walker

Pages: « 1 2
11
General Mach Discussion / Re: turn icon
« on: August 05, 2007, 07:22:58 PM »
chip,
Thanks
Properties is what you posted but it goes to the mill page.

any ideals

thanks

12
General Mach Discussion / turn icon
« on: August 04, 2007, 09:48:44 PM »
my icon for turning is coming up for the mill,what did I do wrong?
thanks

13
General Mach Discussion / getting started cnc
« on: June 30, 2007, 01:25:12 PM »
Ok I need help,I've been making duck calls for a few years,and want to go to a cnc lathe so speed up production.The catch is I've got no ideal  where  to start.seen a few books on e-bay that have a dvd to start.So my question if you were going to do it all over again with out going to school, witch book,how to videos would you use.
Thanks   

14
General Mach Discussion / Re: onwers manual
« on: December 11, 2006, 11:05:18 AM »
Think I got lucky a buddy's son works at a cnc shop and has offered to  help my problem now is finding the plug to go from the cnc to my computer,tryed dell,fry's,radio shack
but they do not sell a 25 pin plug,got any ideals?

thanks

todd

15
General Mach Discussion / onwers manual
« on: December 09, 2006, 05:28:52 AM »
I'm verry hew to cnc,and bought a magnum technology wood cnc late,and am looking for a owners manual,or pay for a copy of it,
they are out of business and I need help,any ideals besides this site(witch it too advanced for me right now)ordered some books,any help would be great
my goal is duck calls been turning them on a wood lathe then finishing them up on a metal lathe.
One last question for now the cutting bit that it came with is no good so I want to try to put a tool post(like the taig-sold threw Lee Valey)will that be a big problem?
the new tool bost it taller than what is in my machine now.

thanks

Todd

Pages: « 1 2