Messages

11

General Mach Discussion / Re: manual tool change macro needed

« on: January 03, 2009, 01:58:47 PM »

Thanks for the replies. Sorry it has been so long but I was away on a mini vacation for the holidays. Softselect, I'm very interested on how you set yours up so if you want, post or email me step by step instructions on how you went about doing it so I can look it over. I have a second parallel port available also and I use inch, not metric.

Thanks!

12

General Mach Discussion / manual tool change macro needed

« on: December 24, 2008, 08:33:49 AM »

Ok, I'm new to the CNC world let alone Mach 3 and writing macros. I have a Taig CNC mill that I would like a simple tool change macro. I would like to send it to the home position to allow plenty or room for the tool change,  make my tool change, allow me to reset the tool z height each tool change since I don't have holders and then continue on with the program. Can someone help a total newbie out?

13

Finished Screens / Re: Ultimate Screen Mill/Lathe/Plasma (TouchScreen and/or Mouse and/or keyboard)

« on: November 29, 2008, 07:18:46 AM »

Is this screenset compatible with the latest lockdown version of Mach 3(3.042.20)?