Messages

111

General Mach Discussion / Mach3-Stop between two parts

« on: February 10, 2009, 02:59:13 AM »

Hi,
I'm asking about how to temporary stop cutting between two parts, and continue later to next part, if I have more parts on one sheet.

Also, how to start (and stop) cutting using push button switch (not using keyboard or mouse)?
Best regards
Mrpeja

112

General Mach Discussion / Re: Mach3 Ports Setup

« on: February 05, 2009, 03:43:00 PM »

Hi, Hood,
Thanks for the reply.
If I understand, you say that Input1 is already predefined to do this, or i must map him, or what?
(I'm new user, little bit of experience)
Mrpeja

113

General Mach Discussion / Mach3 Ports Setup

« on: February 05, 2009, 09:54:44 AM »

Hi all,
I'm analysing THC300 schematic sample printed in Mach3 manual. There is Fault led and Fault output.
Question: Is this output connected to Mach3 and to witch port and pin in Mach3 Ports&pins Menu?
Regards,
Mrpeja

114

General Mach Discussion / Mach3 and video card

« on: February 01, 2009, 01:11:35 PM »

Please explain to me why is needed computer with non-integrated video card.
Most of today's computers has integrated video card.
Mrpeja