Hello Guest it is December 13, 2019, 10:14:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - giordano

Pages: « 1 2 3 4 5 6
51
General Mach Discussion / Re: Tool change
« on: December 15, 2005, 08:08:01 AM »
Hi Brian. Yes, I on my machine have 2 home switch for each axle. I have tried to copy the files M6start.m1s and M6End.m1s of the old version in the new version but you don't work. Excuse for my English.  I am Italian.
Giordano.

52
General Mach Discussion / Tool change
« on: December 15, 2005, 02:05:02 AM »
Hi. The macro tool change doesn't correctly work. In the old version the function M06 positioned the axle Z to the suitable measure in tool change location. Which is the problem? Mach3 version 1.83.032. Regards Giordano

53
General Mach Discussion / Import BMP, JPG, Gerber and Excellon file
« on: November 14, 2005, 08:26:21 AM »
I have noticed that the importation of [files] of BMP type and JPG doesn't work correctly and is produced a file of big sizes in long once. Also the importation of Gerber file and Excellon is not possible. Does anybody have resolved these problems? Thank you

54
General Mach Discussion / Re: Motor tuning
« on: November 12, 2005, 01:42:29 AM »
Thanks.

55
General Mach Discussion / Re: Motor tuning
« on: November 11, 2005, 05:53:21 AM »
Sono Italiano. Ciao.
_________________
Giordano

56
General Mach Discussion / Motor tuning
« on: November 10, 2005, 09:21:08 AM »
Hi. Inserting the number of steps for unit, one changes the speed motto of the motor stepper automatically. Mach3 where does he take these data? Could not he become equally for the accelerations? Inserting any parameters of the stepper motor they could be obtained any combinations of speed and acceleration to experiment. You excuse for my English. Giordano

Pages: « 1 2 3 4 5 6