Messages

41

General Mach Discussion / Discontinuous execution of the contours

« on: April 27, 2006, 08:29:36 AM »

Hi to all. Since I had any losses of step, I have reduced the acceleration of the 10-20s motors mm s/s. As in the figure.
In this way the execution of a circle is not uniform anymore, but to hiccup. There is a cure. Thanks in advance, Giordano

42

General Mach Discussion / Written on aluminum

« on: April 14, 2006, 04:24:29 PM »

Hi. I would like to realize some writings on a panel in aluminum. Which is the good computer program that can work with Mach3?. Thanks in advance, Giordano.

43

General Mach Discussion / Re: Manufacture PCB

« on: April 05, 2006, 06:33:20 AM »

Hi. Excuse for my English. I am Italian. If sending can be useful the files Gerber 274X and the files Excellon both created with the Cam Processor of Eagle 4.13. Eagle is maybe the CAE more diffused free. It has some limitation for the dimensions of the board, but she works completely. It would be a good idea to include in Mach3 the possibility to import the fileses created with Eagle like with Galaad. Thanks, Giordano.

44

General Mach Discussion / Re: Manufacture PCB

« on: April 02, 2006, 07:09:13 PM »

Hi. These are two fileses: 1) created with Proteus and Galaad; 2) produced with Eagle 4.13 and Galaad. Thanks, Jordan

45

General Mach Discussion / Manufacture PCB

« on: April 02, 2006, 06:19:52 PM »

I want to create PCB with the programs Proteus and Galaad. Galaad creates a file ISO. This files ISO is usable with Mach3? Thanks, Giordano

46

General Mach Discussion / Re: Serial Card

« on: January 17, 2006, 05:57:13 PM »

IF it is to get a comport on your computer I think so... I can't read the page

Sorry

I apologize. The site is this http://www.iprocam.com /

47

General Mach Discussion / Serial Card

« on: January 17, 2006, 09:20:57 AM »

Hi to all. I have found a serial card of interface in the site
www.cncitalia.net realized through a microcontroller PIC18F452. Could Mach3 pilot a serial card and like? Thanks, Giordano.

48

General Mach Discussion / Tool compensation

« on: December 18, 2005, 06:21:47 AM »

Hi. How him imposed the compensation of the diameter of the utensil when for example with a cutter of 2.5 mms of diameter a circle of 32.5 mms of diameter is gotten instead of 30 mms of diameter? Thanks. Giordano.

49

General Mach Discussion / Re: Tool change

« on: December 16, 2005, 08:17:47 AM »

Hi Brian. You look the file attachment.

50

General Mach Discussion / Re: Tool change

« on: December 15, 2005, 11:10:06 AM »

I am sorry, but don't work.
Giordano